Read and get familiar with all safety precautions and procedures before using the device. Strictly follow all safety precautions. Ensure that the device is properly assembled and is working properly.
■ Place and use the fire safety set in locations where children are not likely to be present.
■ The fire safety set cannot extinguish all fires or eliminate the risk of danger. Please strictly follow the safety precautions and instructions for the device to ensure fire safety.
■ The fire safety set is applicable only to desktop laser processing devices. Please strictly follow the safety precautions and instructions for the desktop laser processing devices.
■ Equip your workspace with fire extinguishing equipment, including sprinklers and extinguishers, and perform regular inspection and maintenance on them.
■ Do not leave the laser machine unattended when it is working. Once the processing is completed, carefully inspect and clean its internal working area in time to ensure that there is no flame residue.
■ The fire safety set is not suitable for smoke exhaust systems that cannot perform intelligent linkage.
■ Place the fire safety set horizontally. Do not position it vertically or at an angle.
■ After CO2 discharge, do not handle the cylinder immediately. The cylinder surface is extremely cold, posing a frostbite risk. In addition, CO2 ice (dry ice) may form at the cylinder entrance, causing adhesion to internal components. Forcibly removing the cylinder may damage the internal components. Before replacing the cylinder, wait at least 5 minutes after CO2 discharge.
■ Do not remove the cylinder except during replacement. Unauthorized handling may affect weight measurements and trigger false alarms.
■ During CO2 release, ice may form on the device and tube. This is normal and expected.
■ The fire safety set is applicable only to closed processing spaces.
■ The fire safety set works properly at temperatures of 0°C to 35°C.
■ After the fire safety set finishes extinguishing the fire, water droplets may condense on the tube. Please keep it away from live wires to avoid short circuits.
