DTF Film for O1 Omni Printer
Updated Oct 22,2026
Updated Oct 22,2026

This DTF film is designed to facilitate the transfer of UV-printed designs onto fabrics.

How to use

Step 1: Place the DTF transfer film

Place a sheet of the transfer film on the adhesive mat of the standard baseplate. Align the film's four corners with those of the adhesive mat, with the matte side facing up. After attaching the film, gently smooth it along the edges so that it lies flat and adheres firmly to the adhesive mat without curled edges, wrinkles, or air bubbles.

Matte side up

Then install the baseplate with the transfer film onto the printer's extension base.

Step 2: Connect the device

Open xTool Studio, create a new project, and connect the printer.

Step 3: Set parameters and complete printing

Drag or import the design and set parameters.

image.png

Step 4: Apply the powder and cure the film

Remove the printed transfer film and place it on the powder tray with the printed side facing up. Do not touch the printed area.

Apply an appropriate amount of hot melt powder to the transfer film. Hold both sides of the film and gently flex it back and forth so that the powder adheres evenly to the ink. After the printed area is evenly coated, gently tap off the excess powder and set the film aside. Note: - Apply the powder immediately after removing the printed transfer film. If the ink dries, the powder may not adhere properly. - Apply the powder away from the printer.


  1. Apply the powder

  1. Coat the printed area

  1. Pour the excess powder back into the bag. While doing so, gently shake the film to remove as much residual powder as possible.

Step 5: Cure the transfer film

Use the Craft Oven Module of xTool WonderPress. Place the powdered transfer film on the curing base with the powdered side facing up. Then configure the curing settings and start curing.

Powdered side facing up

Example settings:

Mode: Bake & Curing Temperature: 410°F (210°C) Time: 180 s

Step 6: Heat press to flatten the garment

Tip: Cover the garment with a heat-resistant sheet.

- Temperature: 320°F (160°C) - Time: 10 s - Pressure: 80 kg

Step 7: Transfer the design

① Place the garment, transfer film, and heat-resistant sheet in order.

② Configure the settings:

  • Temperature: 320°F (160°C)
  • Time: 10 s
  • Pressure: 80 kg

After heat pressing is complete, pull out the base and peel off the transfer film.

Step 8: Heat press again

Heat press the garment again to make the print more durable and resistant to washing.

Cover the garment with a heat-resistant sheet, and heat press it using the following settings: - Temperature: 320°F (160°C) - Time: 10 s - Pressure: 80 kg

Video tutorial

Preview
Was this page helpful?
1 out of 1 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
xTool Logo

Contact Us

🇺🇸+1 (833) 588-4887
Service Live Chat

Copyright © 2026 xTool All Rights Reserved.