How to Switch to Planar Mode for Laserbox Rotary
Updated Dec 14,2023
Updated Dec 14,2023
  1. Unpack the carton, and take out the honeycomb plate, baffle, and basswood board as the picture shows. Then open the lid of the machine and find the screw bag, remove it from the inside surface of the drawer.

  1.  Using a screwdriver remove two screws as the picture shows then pull out the drawer.

  1. Using screws to assemble the drawer and baffle (if you want to switch the rotary engraving mode more easily, you can consider not installing the baffle).

  1. Installing the honeycomb plate into the machine along the slot, and then fixing the screws on both sides of the honeycomb plate with screws and spacers (the screws on both sides of the honeycomb plate can be fixed as needed).

  1. Installing the drawer and fixing the drawer with 2 screws.

  1. Let‘s run the machine and get the crafts you want.

 

 

Was this page helpful?
0 out of 0 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket
Copyright © 2024 xTool All Rights Reserved.
Call Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales Hotline
+1(970)638-7030
Customer Service Hotline
+1(775)587-7760
Email Us
Service Time
Mon-Fri,9:00-18:30 PDT
Pre-sales and shipping related
vicky@info.xtool.com
vicky@xtool.com
After-sales and shipping related
support@info.xtool.com
support@xtool.com
Technical Support
support@info.xtool.com(US)
support@xtool.com(US)
support.eu@xtool.com(EU)
support.uk@xtool.com(UK)
Brand Cooperation
If you want to cooperate with
xTool on causes like education,
public welfare, innovation, etc.,
or if you want to review our
machines, please email
partner@xtool.com
US headquarter
XTL US INC. 16035 Arrow Hwy.
Irwindale. CA91706
Copyright © 2024 xTool All Rights Reserved.