Poor results

Optimization solutions

The engraved pattern is not clear.

Reduce the layer height or point spacing value.

Some areas of the engraved pattern are not clear.

Increase the power or reduce the processing speed for the entire pattern.

Flickering or cracks appear.

Reduce the power or increase the processing speed, or increase the point spacing.

Texture contrast is not clear.

• Choose textured models with distinct color contrasts in their patterns.
• Avoid textured models that contain a large amount of black.

The position of the engraved pattern is too high or too low.

• Ensure that the height and dimensions of the glass match the model.
• Perform inner engraving Z-axis calibration.

The position of the engraved pattern shifts forward, backward, left, or right.

• If the positioning piece is used, ensure that the value indicated by the triangle mark on the riser top plate matches the value displayed on the Inner Engraving Settings page in xTool Studio.
• If the positioning piece is not used, ensure that the X-axis and Y-axis coordinates of the material, as seen on the riser top plate, match the Bottom-Left Corner Coordinates on the Inner Engraving Settings page in xTool Studio.
• Perform inner engraving work area calibration.

Layer break occurs.

Reduce the opening and closing of the protective enclosure during processing, as it can cause vibrations.