Connect xTool F1 to XCS

1. Use the USB cable to connect xTool F1 to your computer.

2. Open XCS on your computer. On the top-right corner of XCS, click Connect device.

3. On the Devices list, click the name of your device to connect it.

Set up xTool F1 in XCS

1. On the top right corner of XCS, click the gear icon next to the xTool F1 image to open the device setting window.

2. Click Setting, and turn on or off the feature based on your needs.

• Flame alarm: If a flame is detected, xTool F1 will pause processing and raise the alarm. For safety purposes, you are advised to turn on this feature.
• Stops when moved: If xTool F1 is moved or tilted during processing, it will pause processing. To use xTool F1 to process materials with slopes, you need to turn off this feature.
• Stops when enclosure opened: If the protective enclosure is opened during processing, xTool F1 will pause processing. To use xTool F1 to process materials with the protective enclosure opened, you need to turn off this feature.
• Infrared ray preheat: Using the infrared laser for bitmap engraving at a low temperature may lead to unsatisfying engraving results. To ensure better engraving results, you can turn on this feature, so that the laser module is preheated to enter the optimum state before processing.
• Buzzer reminders: If it is enabled, the buzzer on xTool F1 sounds when the device enters some particular states, such as getting ready for processing or processing completed.