Account Center

If the material you are using cannot be found in the material list with parameter settings, you can test the parameters yourself with the Material Test Array. The Material Test Array function in xTool Studio generates automatic test arrays (available for both bitmap and vector files) for your design patterns. In this way, you can visualize the effect of different parameters on the final product.

To begin, make sure your machine is connected before running the material test array. This is important to validate the results for your specific device.

Step 1

Create an element or import a design file (Both vector and bitmap files are supported for testing).

Step 2

Set the processing type and all the related parameters. These settings will become the default value of the material test array.

Step 3

Select the element, navigate to the left bar, click “Applications”, and select "Material Test Array".

Next, you will see a pop-up setting panel as shown below. While the current table carries default values, feel free to change power and speed according to your project's needs. 

• The X columns represent power; here, you can set the maximum and minimum power, the number of columns in the array, and the spacing between columns.
• The Y rows represent speed, and similarly, you can set the maximum and minimum values, number of rows, and spacing between rows.
• Note: The available parameters vary depending on the device, such as power, speed, and number of passes. Select and set the parameters you wish to test.

Step 4

Click 'Done' to generate a test array on the canvas. This array is based on your parameter settings with an equal difference value for each element. The testing array is grouped automatically, but you can adjust each element individually by ungrouping it. Finally, you could get the products containing renderings with different parameter settings.

Note: The title of the array needs to be configured separately with Cut, otherwise half the value of the default power/speed of the linked device will be used.

Reminders:
Please be aware that if there are too few elements, the coordinate number or title might overlap. To resolve this issue, simply adjust the size or change the title. 
When setting parameters, referring to the recommended parameters for your machine and specific material is important. If the parameters are extremely high or low, you may cause fire when processing. Also, please watch the machine when processing.

Recommended version: xTool Studio 1.0 or above.