Issue description
The processing task does not start when you press the Button Switch or Pedal Switch after clicking "Start" in the xTool software.
Possible causes
- The Button Switch or Pedal Switch is malfunctioning.
- The accessory port on F1/F1 Lite is malfunctioning.
- The switch is connected to the wrong port.
Troubleshooting
Step 1: Connect the switch to the correct port
Ensure that the Button Switch or Pedal Switch is connected to the reserved port on the back of F1/F1 Lite, as shown in the image below.
⚠️ Important: Make sure to use the reserved port on the back, as the switch will not work when connected to the extension port on the side.
Step 2: Use the USB-C connector on the cable
Note: Do not use the Mini-USB connector.

Step 3: Update the software to the latest version

Still experiencing issues?
Should the issue persist after completing the preceding steps, submit a ticket via the "Submit a Ticket" button in the "Help Ticket" section below. The standard response time for xTool Customer Service is one business day.
For a prompt resolution, please include the following details:
- Issue description: A detailed explanation of the observed problem.
- Video evidence: Attach a video demonstrating the issue, where applicable.
- Troubleshooting performed: Any troubleshooting steps you have already attempted, along with their results.
This information is crucial for xTool technical support engineers to provide timely assistance.
Documentation feedback
Help improve this content by providing feedback. If this content did not meet your requirements, select "No" in the "Was this page helpful?" section below. Include specific details about what was unclear or missing in the pop-up suggestion box. Feedback submissions are reviewed by xTool technical writers to enhance future documentation.
