Note：
The Ethernet connection is currently only applicable to the xTool P Series. 
Confirm that both ends of the network cable are tightly connected and undamaged. If the network cable is damaged, replace it with a new one and try to connect again.

(1) Insert one end of the network cable into the Ethernet port of the xTool device and the other end into the computer.

(2) Open XCS on your computer. On the top-right corner of XCS, click the + New project button.

(3) On the right side of the project editing page, click Connect device. 

Note: If you have connected an xTool device in XCS before, click the icon > Connect device.