To engrave cylindrical omaterials, you can use xTool D1 Pro with Rotary Attachment 1 (RA1).

1. Install RA1

(1) Install risers.

Note: No riser is included in the pack. You need to purchase risers before using them.

(2) Disconnect the motor on the left plate from the main control board.

(3) Connect RA1 to the main control board, and place RA1 in the working area of xTool D1 Pro.

Note: Make sure that RA1 is parallel to the working area of xTool D1 Pro.

Adjust the level of RA1

Before connecting RA1 to xTool D1 Pro, you can set the level of RA1 based on the diameter of a material to be processed.

Level reference

Set the level

For example, change the level from 3 to 2.

2. Use RA1

(1) Connect xTool D1 Pro to a power supply and turn it on.

(2) Connect xTool D1 Pro and your computer by using the USB cable.

(3) Open XCS and connect xTool D1 Pro to XCS.

(4) Select the Laser cylindrical processing type.

(5) Select the Roller mode.

Note: Currently, RA1 provides roller components only.

(6) Import a project file, insert an element, or draw your artwork on the canvas. For example:

(7) Set the parameters, and click the Start.

(8) Set start point for processing.

(9) Click Framing to preview the processing area on the material. Make sure the design elements are to be processed on the material.

(10) Click Start in the upper right corner.

(11) Wait for the processing to complete.