xTool Air-Compress Assist is an accessory that can help improve the engraving and cutting performance of xTool M1. 

This document describes how to connect this accessory to M1 and how to use it for processing. The organization is as follows:

• Connect xTool Air-Compress Assist with M1
• Use xTool Air-Compress Assist
• Replace the filter

Connect xTool Air-Compress Assist with M1

1. Remove the baseplate of M1

Lift the lid of M1 and loosen the five screws securing the baseplate from inside the machine, then remove the baseplate and put the lid back on.

2. Install the lens mount and nozzle component

(1) Turn M1 over and move the laser module to the center of the processing area.

(2)

(3)

(4)

(5)

(6)

(7)

3. Install tube clamps

(1)

(2)

(3)

(4)

Note: Pay attention to the positions of the tube for clamping at the tube clamps.

4. Install the air pump

(1)

(2) After installing the air-compress assist, move the laser module to each of the four corners of M1. Ensure that the tube doesn't block the movement of the laser module.

5. Connect to a power supply

Use xTool Air-Compress Assist

Replace the filter