Use xTool Air-Compress Assist on xTool M1
Updated Nov 29,2024
Updated Nov 29,2024
xTool Air-Compress Assist is an accessory that can help improve the engraving and cutting performance of xTool M1.
This document describes how to connect this accessory to M1 and how to use it for processing. The organization is as follows:
- Connect xTool Air-Compress Assist with M1
- Use xTool Air-Compress Assist
- Replace the filter
Connect xTool Air-Compress Assist with M1
Remove the baseplate of M1
Lift the lid of M1 and loosen the five screws securing the baseplate from inside the machine, then remove the baseplate and put the lid back on.
Install the lens mount and nozzle component
(1) Turn M1 over and move the laser module to the center of the processing area.
(2)
(3)
(4)
(5)
(6)
(7)
Install tube clamps
(1)
(2)
(3)
(4)
Note: Pay attention to the positions, of the tube, for clamping at the tube clamps.
Install the air pump
(1)
(2) After installing the air-compress assist, move the laser module to each of the four corners of M1. Ensure that the tube doesn't block the moving of the laser module.
Connect to a power supply
Use xTool Air-Compress Assist
Mode for engraving
Mode for cutting
Replace the filter
Preview
Was this page helpful?
2 out of 4 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Tags
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Call Us
Telephone Pre-sales : +1(970)638-7030
After-sales : +1(775)587-7760
Email Pre-sales : vicky@info.xtool.com
After-sales : support@info.xtool.com
Service Time Mon-Fri : 7:00 am - 5:30 pm (PT)
Sat-Sun : 8:30 am - 5:30 pm (PT)
Join xTool Squad
Copyright © 2024 xTool All Rights Reserved.