Use xTool Air-Compress Assist on xTool M1 Ultra

Updated Nov 28,2024

xTool Air-Compress Assist is an accessory that can help improve the engraving and cutting performance of xTool M1 Ultra. In auto mode, this accessory can adjust its own power to accommodate the laser module and processing tasks.

Using the wireless dongle included in the pack, you can connect xTool Air-Compress Assist to M1 Ultra via 2.4 GHz wireless network.

This document is organized as follows:

Connect xTool Air-Compress Assist with M1 Ultra
Use xTool Air-Compress Assist
Pair xTool Air-Compress Assist with M1 Ultra again
Replace the filter

Connect xTool Air-Compress Assist with M1 Ultra

Obtain and connect the wireless dongle

Connect the tube

Connect to a power supply

Use xTool Air-Compress Assist

Mode for engraving

Mode for cutting

Auto mode

Pair xTool Air-Compress Assist with M1 Ultra again

If the wireless dongle is missing or faulty, please contact our after-sales services or your distributor to obtain a new one. After receiving the new dongle, pair the accessory with your device again. The following are the steps:

Step 1. Insert the wireless connection reset pin into the reset hole. Hold for one second and remove the pin.

Step 2. Insert the new wireless dongle into the extension port of M1 Ultra. Wait until the wireless connection indicator turns from white slow blinking to solid white.