4.Added the "Align center" function that aligns the centers of the selected objects.

 

 

5.Added the "Select object" and "Arrange" functions to the shortcut menu of the canvas, which allow you to select a covered object and set the stacking order of an object, respectively.

 

6.Added the vector scissors function for deleting a path between two nodes.

 

7.Added the functions for making, editing, and releasing compound vectors.

 

8.Optimized the Boolean operation logic, supporting Boolean operations on non-closed vector paths

 

 

9.Optimized the driver installation process: added the "No more reminders" choice for users who do not need to install the drivers. After you select "No more reminders", XCS will not prompt you to install the driver. If you've bought a new computer and need to install a driver, you can go to "Settings" > "Develop mode" to install it.

 

 

10.Added the "From bottom to top" scanning way for vector fill engraving and bitmap engraving.

 

 

11.Added the kerf offset function to compensate for the cut width that makes the pieces you cut a little bit smaller than expected.

 

 

12.Optimized the planning of the cutting path. For complex patterns, the rapid traverse path can be reduced by 80% or more, which makes the cutting process more orderly and efficient.

13.Added the focus lowering function for xTool P and M series to enhance the ability of the machines to cut thick materials.

 

14.Added the tab generation function for cutting to prevent the parts from falling out or moving during the cutting process.