xTool Store
The Rotary Attachment Stops Mid-Job
Updated Dec 21,2023
Updated Dec 21,2023
This article applies to:
D1 and D1 Pro
Rotary Attachment
Issue Description
If the rotary attachment stops during the processing, please refer to this article for troubleshooting.
#1 Check the Connection Cable
- Check if the connection cable is loose or damaged.
- If it's loose, unplug and replug the cable.
- If it's damaged, contact tech support for advice.
#2 Check the Rotary Motor
- Disconnect the rotary attachment.
- Roll the roller or the chuck by hand.
- See if there is any blockage in the movement.
- Refer to this video to fix the issue:
[Video]How to Solve the Motor Blockage Problem for the Rotary Attachment
#3 Check the Firmware Version
Make sure the firmware is up-to-date. You can refer to the articles below on how to check and upgrade your firmware. Upgrade the Firmware for D1 and D1 Pro
If None of the Above Works
If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.
Preview
Was this page helpful?
0 out of 0 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket Tags
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Submit a Ticket 
Services & Help
Learn & Education
Copyright © 2025 xTool All Rights Reserved.