User

support

Member since
Total activity 300
Last activity
Following 0 users
Followed by 4 users
Votes 5
Subscriptions 153

Activity overview

Latest activity by support

  • support created an article,

    How to replace the Y-axis belt

    • support
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    Power Attenuation Due to the Lens of the 20W Laser Module

    #1  The 20W laser module can't cut through a 10mm basswood board due to its lens. What can I do? Possible problem 1:  The lens on the copper cap of the laser module is dirty. 1. Why does it become...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    Common processing problems

    Laser engraving: #1  The laser engraving pattern is not clear Reason 1: Inaccurate focus. Solution. Place your material under the laser head, lower the support bar loosen the rotating screw, the...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    Common processing problems

    1. Why the laser head does not emit the laser beam after the machine starts working? Shut down the machine, loosen the 8 screws of the laser tube protective cover (as shown in the figure below), re...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    Common processing problems

    I.  Laser engraving processing: #1  The laser engraved pattern is not clear Reason 1 : Inaccurate focus. Solution : Re-measure the height of the material or manually measure to ensure correct f...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    Use xTool Creative Space (XCS) to Operate xTool D1

    This page describes the functions of xTool Creative Space (XCS) and how to use it. Obtain and install XCS Quick start example 1. Select a language 2. Connect your device to XCS 3. Place a material...

    • support
    • Updated
    • 3 followers
    • 0 comments
    • 0 votes
  • support created an article,

    Air Assist Set User Guide

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    The Template For Product Failure Description(Laserbox P)

    1. SN barcode SN label of laserbox (at the switch of laserbox) 2. Firmware version Laserbox Working Hours, Firmware, Serial Number, Device state (provide photos or screenshots [Settings] - [Devic...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    20W Laser Module of xTool D1

    Statement Thank you for choosing the xTool products! If you use the product for the first time, read carefully all the accompanying of the product to improve your experience with it. If you ...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes
  • support created an article,

    10W Laser Module of xTool D1

    Statement Thank you for choosing the xTool products! If you use the product for the first time, read carefully all the accompanying of the product to improve your experience with it. If you d...

    • support
    • Updated
    • 1 follower
    • 0 comments
    • 0 votes