Solutions to Common XCS Notice/ Alerts for D1 Pro

Article author
support
  • Updated

Contents:

#1 "No TF card is detected in the device. Please insert the TF card, restart the machine and try again."

#2 "The device has been moved."

#3 "A flame is detected."

#4 "The laser module has moved over the position limit."

----------------------------------------------------------------------

#1 "No TF card is detected in the device. Please insert the TF card, restart the machine and try again."

Problem:

1280X1280__8___1_.PNG

Solutions:

1. Power off D1 Pro, reinstall the TF card and try again.

2. Replace the TF card with another in case it was damaged and try again.

#2 "The device has been moved."

Problem:

image__1___1_.png

Solutions:
1. Place the machine on a steady and flat surface, avoiding tilting or shaking.
2. Turn off  Stops when moved if necessary.

__20220829-155722.jpg

screenshot-20220921-173518.png

#3 "A flame is detected."

Problem:

1280X1280__9___1_.PNG

Solutions:

1. Click on the gear icon and select Low sensitivity for the Flame alarm.

__20220829-155722.jpgf89a9ed5-3d51-4b6f-a525-6b90c3a30d6d__1_.png

2. Set a lower Power and/or Density value, and/or set a higher Speed value when processing on an inflammable material.

3. Replace the Flame Sensor in case it is malfunctioning.

Note: Do not use the machine under direct sunlight or accent light.

#4 "The laser module has moved over the position limit."

Problem:

1280X1280__10___1_.PNG

Solutions:

1. Check and make sure the ends of the limit switch cable are connected properly.

2. Check and make sure the limit switch sensor is not contaminated.

3. Replace the limit sensor(s) in case it was malfunctioning.

4. Turn off the Limit switch if necessary.

__20220829-155722.jpg

screenshot-20220921-173617.png

Was this article helpful?

4 out of 7 found this helpful

Have more questions?