Statement
-
Thank you for choosing the xTool products!
-
If you use the product for the first time, read carefully all the accompanying of the product to improve your experience with it. If you do not use the product according to the instructions and requirements of the Manual, or mis-operate the product due to misunderstanding, etc., Makeblock Co., Ltd. Shall bear no responsibility for any loss resulting therefrom, except for losses caused due to improper installation or operation by Makeblock professional maintenance personnel.
-
Makeblock Co., Ltd. has collated the content of the Manual rigorously and carefully, but errors or omissions may remain.
-
Makeblock Co., Ltd. is committed to continuously improving product functions and service quality, and therefore reserves the right to change any product or software described in the Manual and the content of the Manual at any time without prior notice.
-
The Manual is intended to help you use the product properly and does not include any description of hardware and software configuration. For product configuration, refer to the related contract (if any) and packing list, or consult your distributor. Images in the Manual are for reference only and the actual product may vary.
-
Protected by copyright laws and regulations, the Manual shall not be reproduced or transcribed in any way, or be transmitted on any wired or wireless network in any manner, or be translated into any language without the prior written authorization of Makeblock Co., Ltd.
List of items
1. Laser module x 1

2. Power adapter x 1

Replace the laser module

-
Remove the original laser module.
(1)Move the cable out of the slot, press the connector, and unplug the connector.

(2)Turn the screw counterclockwise to loosen it, and remove the screw and laser module.

-
Install the new laser module.
-
Complete the wiring.
Wiring tips:

Note: If the original laser module is the 5-watt one, you need to replace the power adapter with the one delivered with the 10-watt laser module.
Declaration of Conformity
Hereby, Makeblock Co., Ltd. declares that this product is in compliance with the essential requirements and other relevant provisions of Directive RED 2014/53/EU and the RoHS directive 2011/65/EU & (EU) 2015/863.
After-sales services
For technical support, contact us through support@xtool.com.
For more information about after-sales services, visit support.xtool.com.
Comments
0 comments
Please sign in to leave a comment.