Skip to main content
xTool Help Center home page
  • Contact Us
  • Sign In
SHOP
  1. xTool
  2. xTool M1
  3. Maintenance Tutorials

How to Replace the Laser Driver Board、Cable and Fan for M1

Article author
support
  • Updated May 12, 2022 10:06

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Related articles

  • How to Clean Photosensors for M1
  • How to Replace the Laser Module for M1
  • How to Replace the Hall Sensors for M1
  • Use xTool Creative Space (XCS) to Operate xTool M1
  • xTool D1 Laserbox Basic Software-For Laser Newcomer

Comments

0 comments

Please sign in to leave a comment.

Articles in this section

  • How to maintain the M1 guide rails？
  • How to Disassemble and Assemble the M1
  • How to Replace the Y-axis Limit Switch for M1
  • How to Replace the Wifi Antenna for M1
  • How to Replace the Camera Module for M1
  • How to Replace the Main Control Board for M1
  • How to Maintain the Y-axis Slide Rails for M1
  • How to Replace the Z-axis Adapter Board for M1
  • How to Replace the Laser Lens for M1
  • How to Replace the Smoke Exhaust Fan for M1

See more

Support

Still need help? Our team of experts are just a click away

Contact Us
Website
  • www.xtool.com
    •
Products
  • Laserbox Rotary
  • xTool D1
  • xTool M1
  • Accessory
  • Material
Contact Us
  • Business Cooperation:Hello@xtool.com
  • Pre-sales and Logistics:
    vicky@info.xtool.com vicky@xtool.com
  • Technical Support:
    support@info.xtool.com support@xtool.com
  • Office Hours: Mon-Fri, 9:00-18:30 PDT
  • Service Hotline: + 1 (775) 587-7760

Copyright © 2021 xTool All Rights Reserved.