How to guarantee the graphics in material engraving/cutting

Article author
support


Since D1 works from the current laser head IR cursor position by default, in continuous mode, after each click to send, you have to click the button to make the laser head go to the boundary and observe whether the laser head trajectory exceeds the surface area of the material.

If not, you need to move the position of the material to cover the rotation of the laser head, click again to go to the boundary, observe until the laser head's trajectory is entirely within the surface area of the material, and then click the Start button.

 

Was this article helpful?

1 out of 3 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.