How to Replace Laserbox Machine Parts

Article author
support
  • Updated

Cotents

1. How to fill the coolant

2. How to replace the RGB board

3. How to replace the Y1 board

4.How to replace the mainboard

5. How to replace the Z axis adapter cable

6. How to replace the laser power supply

7. How to replace the laser tube

8. How to replace the water tank

9.How to replace the water pump

10.How to replace the Z-axis adapter plate

11.How to adjust laser path

1. How to fill the coolant

 

2. How to replace the RGB board

3. How to replace the Y1 board

4.How to replace the mainboard

 

5. How to replace the Z axis adapter cable

Attention: 
 
For faster verification, you can plug the ends of the cable directly into the connectors on the motherboard and the Z-axis adapter board.
Then you can try to engrave a project in the upper left corner and see if the laser head will touch the material. If it doesn't touch, it must be caused by the Z-axis cable, and you can try to replace it by referring to the link. If it still doesn't fix it, that will be another cause. Be careful not to damage the new cable during the test.

6. How to replace the laser power supply

 

7. How to replace the laser tube

We have two types of laser tubes (refer to the picture below), their installation methods are slightly different, please select the installation instruction video according to the model you got.

__________.png

For Model 1

For Model 2

8. How to replace the water tank

 

9.How to replace the water pump

 

10.How to replace the Z-axis adapter plate

11.How to adjust laser path

Was this article helpful?

1 out of 1 found this helpful

Contact Us

Comments

0 comments

Please sign in to leave a comment.