Light Path Calibration Tool

Article author
  • Updated

1. The operation process please refer to below video.

2. Download the laser launcher tool:

1.The default setting  parameter of laserlauncher tool  is PWM:6    Launch time:1mm (change the language to English)
2.If you could not found the path dot, please increase the power value and the launch time gradually.
PWM increase 10 each time 
Launch time increase 10 each time
3.If you found the dot too large ,please slightly reduce the parameter value.
4.The laserlauncher could only run under windows os

3. Setting parameter:


4.The correct position of the light path. It’s okay if the position is slightly off




If you found that no matter you setting the patameter ,the laser still cam not leave mark on the tape.
you could try to engrave a square in the upper right corner of honeycomb board with using 6% Power. Lift the lid or turn off the machine as soon as the laser leaves a mark on the tape.



Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request



Please sign in to leave a comment.