How to replace the Z axis adapter cable

Article author
support
  • Updated

 

Attention:  for faster verification, you can plug the ends of the cable directly into the connectors on the motherboard and the Z-axis adapter board.
Then you can try to engrave a project in the upper left corner and see if the laser head will touch the material. If it won't touch, then it must be caused by the Z-axis cable and you can try to replace it by referring to the link. If it still doesn't fix it, that will be another cause. Be careful not to damage the new cable during the test.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.