Unboxing-how to start planar engraving module

Article author
support
  • Updated

1.Unpack the carton,take out the honeycomb plate ,baffle and the basswood board as picture shows. Then open the lid of machine and find the screw bag ,remove it from the inside surface of drawer.

mceclip0.png

mceclip1.png

mceclip2.png

2.Using screw driver remove two screws as picture shows then pull out the drawer

mceclip3.png

3.Using screws to assemble the drawer and baffle (if you want to switch the rotary engraving mode more easily, you can consider not installing the baffle)

mceclip4.png

4.Installing the honeycomb plate into the machine along the slot, and then fix the screws on both sides of the honeycomb plate with screws and spacers (the screws on both sides of the honeycomb plate can be fixed as needed)

 

mceclip0.png

mceclip1.png

 

5.Installing the drawer and fix the drawer with 2 screws

mceclip8.png

mceclip9.png

6.Let‘s run the machine and get the crafts you want.

 

 

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.