The Process Button on XCS Won't Work
This article applies to:
D1 and D1 Pro with all laser modules.
When you use XCS, get the design file ready, set the parameters, and are about to start a job, you may find nothing happens when you click on the 'Process' button, and the loading sign stays. Please follow the instructions below to troubleshoot the issue.
#1 Check the Firmware Version
Make sure your machine's firmware is up-to-date.
Refer to this guide on how to check the version and upgrade.
#2 Check the XCS Version
Make sure the XCS software is up-to-date.
Refer to this article on how to find the version.
#3 Check the XCS Cache
Please refer to the following steps to clean the cache.
Make sure the XCS is not running. Close it if it is.
Go to the cache folder according to the paths below. Remember to replace the User Name in the following path with your actual user name.
C:\Users\User Name\AppData\Roaming\xTool Creative Space\Local Storage
/Users/User Name/Library/Application Support/xTool Creative Space/Local Storage
Delete all files under the Local Storage folder.
Relaunch XCS and see if it works.
Article is closed for comments.