The Flame Detector Won't Work

    Article author
    Cecilia Fang
    • Updated

    This article applies to:

    D1 Pro with all laser modules.

     

    Issue Description

     
    When you use the machine, if you find the the flame detector won't work, please follow the instructions below to troubleshoot.
     

    Check The XCS Setting

    Please make sure the flame alarm function is enabled in the setting and try high sensitivity.
    High_Sensitivity-Xcs.png

    Note:
    If a fire happens during the processing, please help us note down your material and processing parameters such as speed, and power. Contact us and report the incident. This will help us improve the product.

    Tip:
    To further fire proof your working environment, we recommend the fire safety set: https://www.xtool.com/collections/accessory/products/fire-safety-set

    If None of the Above Works

    If you have followed the instructions above and the issue is still not resolved, please read the article in the link below, collect the troubleshooting steps you have taken, and contact xTool tech support for further advice.



    Was this article helpful?

    0 out of 1 found this helpful

    Have more questions?

    Comments

    0 comments

    Article is closed for comments.