Install 10W Laser Module on xTool D1
Updated Sep 6,2023
Updated Sep 6,2023
Contents
1. Remove the original laser module
2. Install the new laser module
List of items
Laser module x 1
Power adapter x 1
Replace the laser module
1. Remove the original laser module
（1）Move the cable out of the slot, press the connector, and unplug the connector.
（2）Turn the screw counterclockwise to loosen it, and remove the screw and laser module.
2. Install the new laser module
Place the laser module into the slot and tighten the thumb screw.
3. Complete the wiring
Insert the connector of the connection cable into the port of the laser module, and place the cable and cable sleeve into the slot.
Wiring tips:
Note: If the original laser module is a 5-watt one, you need to replace the power adapter with the one delivered with the 10-watt laser module.
Preview
Was this page helpful?
0 out of 0 found this helpful
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Tags
Help Ticket
Use this help ticket to submit your issue. We will respond within 1 business day
Call Us
Telephone Pre-sales : +1(970)638-7030
After-sales : +1(775)587-7760
Email Pre-sales : vicky@info.xtool.com
After-sales : support@info.xtool.com
Service Time Mon-Fri : 7:00 am - 5:30 pm (PT)
Sat-Sun : 8:30 am - 5:30 pm (PT)
Join xTool Squad
Copyright © 2024 xTool All Rights Reserved.