Buttons

Up/Down button for laser module: Lifts or lower the laser module for laser focusing

Framing button: Starts or stops framing

Start/Stop button: Starts or stops processing

User interface

When xTool F1 Ultra is turned on, the touchscreen controller lights up. The touchscreen interface is as follows:

The icon in the top-right corner of the touchscreen indicates the connection status between the device and the software XCS.

The icon in the top-left corner of the touchscreen indicates the device's connection mode.

Was this page helpful?

12 out of 13 found this helpful

Help Ticket

Use this help ticket to submit your issue. We will respond within 1 business day

	Unconnected
	Connected to the software via USB cable
	Connected to the software via Wi-Fi

	The device becomes an access point (AP), or hotspot. You can connect XCS to the device in hotspot mode.
(No icon displayed)	The device is not in hotspot mode. To turn the device to a hotspot, press the XTOOL Start/Stop button on the touchscreen controller for 5 seconds until the device beeps and the AP icon is displayed.